SODIUM POLYSTYRENE SULFONATE Suspension [Paddock Laboratories, LLC]

The average daily adult dose is 15 g (60 mL) to 60 g (240 mL) of suspension. This is best provided by administering 15 g (60 mL) of Sodium Polystyrene Sulfonate Suspension, USP one to four times daily. Each 60 mL of Sodium Polystyrene Sulfonate Suspension, USP contains 1500 mg (65 mEq) of sodium. Since the in-vivo efficiency of sodium-potassium exchange resins is approximately 33%, about one-third of the resin’s actual sodium content is being delivered to the body.

In smaller children and infants, lower doses should be employed by using as a guide a rate of 1 mEq of potassium per gram of resin as the basis for calculation.

Sodium Polystyrene Sulfonate Suspension, USP may be introduced into the stomach through a plastic tube and, if desired, given with a diet appropriate for a patient in renal failure.

Sodium Polystyrene Sulfonate Suspension, USP may also be given, although with less effective results, as an enema consisting (for adults) of 30 g (120 mL) to 50 g (200 mL) every six hours. The enema should be retained as long as possible and followed by a cleansing enema.

After an initial cleansing enema, a soft, large size (French 28) rubber tube is inserted into the rectum for a distance of about 20 cm, with the tip well into the sigmoid colon, and taped into place. The suspension is introduced at body temperature by gravity. The suspension is flushed with 50 or 100 mL of fluid, following which the tube is clamped and left in place. If back leakage occurs, the hips are elevated on pillows or a knee-chest position is taken temporarily. The suspension is kept in the sigmoid colon for several hours, if possible. Then the colon is irrigated with a sodium-free cleansing enema at body temperature in order to remove the resin. Two quarts of flushing solution may be necessary. The returns are drained constantly through a Y tube connection. While the use of sorbitol is not recommended, particular attention should be paid to this cleansing enema if sorbitol has been used.

The intensity and duration of therapy depend upon the severity and resistance of hyperkalemia.

Sodium Polystyrene Sulfonate Suspension, USP should not be heated for to do so may alter the exchange properties of the resin.

Close

Let's block ads! (Why?)

SODIUM POLYSTYRENE SULFONATE Suspension [Paddock Laboratories, LLC]